Vario PRO Underfloor Heating Decoupling Solution

For Underfloor heating

Vario PRO brings underfloor heating and uncoupling technology together in one fast track solution.

Save time by preparing your substrate and installing electric underfloor heating all in one hit!

A watertight solution

Seal the edges, room corners and any penetrations with Vario PRO sealing tape to create a water tight wetroom floor quickly and easily.

Add an underfloor heating cable for extra comfort and luxury!

5.5mm thickness

An uncoupling membrane

Vario ProMat is an uncoupling membrane and crack isolating system with under tile heating.

Vario PRO makes it possible to install tiles and electric underfloor heating on difficult substrates.

The post Tile Matting – Decoupling Membrane For Laying Loose Cable Electric Underfloor Heating – 1m2 appeared first on The Underfloor Heating Site.

Our underfloor heating for tiles, porcelain or stone comes in the form of electric cable that mats allow underfloor heating to be laid over large areas in a short amount of time. They are externally versatile, offering the flexibility to heat any room shape and size.

The cable mat system is similar to other loose cable systems, except that the cable comes ready taped to a 50cm wide fibreglass mesh. This makes it much faster and manageable to lay in larger open plan areas.

The 200w Mat is based on the same design as 150w mat but the output has been increased to 200 watts per square metre making it ideal for underfloor heating in conservatories and glass rooms and other areas where there is more heat loss.

Please Note: Floor coverage is calculated as 85% of the total floor due to the gaps between each run and perimeter gap between the wall and the mat.

Each cable mat system comes complete with:

1. Heating cable supplied woven to a self adhesive mesh
2. Fully programmable thermostat controller with floor probe
3. Floor primer
4. Roller for primer
5. Simple installation instructions
6. Manufacturers lifetime warranty

Want a slightly lower wattage electric underfloor heating for tiles? Try the 150w version – Take A Look Here

The post Electric Underfloor Heating Mat For Tiles Porcelain Or Stone – 200w Cable Mat Kit appeared first on The Underfloor Heating Site.

Cable mats allow underfloor heating to be laid over large areas in a short amount of time. They are externally versatile, offering the flexibility to heat any room shape and size.

The Varme cable mat system is similar to the Varme and other loose cable systems except that the cable comes ready taped to a 50cm wide fibreglass mesh. This makes it much faster and manageable to lay in larger open plan areas.

The 150w Varme Mat is based on the same design as 200w mat but the lower output at 150 w /m² makes them ideal for all internal rooms, giving approximately 130w per sqm at 85% floor coverage.

Please Note: Floor coverage is calculated as 85% of the total floor due to the gaps between each run and perimeter gap between the wall and the mat.

Each Varme cable mat system comes complete with:

1. Heating cable supplied woven to a self adhesive mesh
2. Fully programmable thermostat controller with floor probe
3. Floor primer
4. Roller for primer
5. Simple installation instructions
6. Manufacturers lifetime warranty

The post Varme Premium Electric Underfloor Heating Mat Cable Mat Kit 150w appeared first on The Underfloor Heating Site.

By far our most popular system for bathrooms for it’s flexibility in covering any shape and size of room. Like the cable mat it can be laid onto existing floors and covered by tile adhesive but comes as one length of cable which is laid out and run into any shaped room or area. Loose cable kits can be used in any room no matter how irregular the shape.

In order to select the correct cable kit size you must first measure the free floor area of the room. When calculating the size, please remember to exclude the area taken up by any fixed objects such as baths, showers, kitchen units etc.

For larger areas than those detailed on the chart please contact us for further information as these areas have a different electrical installation than standard sizes.

Each loose cable kit comes complete with:

• Varme heating cable supplied on a drum
• Fully programmable thermostat controller with floor probe
• Floor primer
• Roller for primer
• Adhesive tape to hold cable in place before tiling
• Simple installation instructions
• Manufacturers Lifetime Warranty

The post Varme Electric Underfloor Heating Loose Cable Kit appeared first on The Underfloor Heating Site.

The Varme loose cable electric underfloor heating is used when the cable is capable of being installed below the floor typically within a 60 to 100mm of concrete screed. With a heat output of 20w per linear metre this system can act as a primary heat source and can be used under almost any floor covering.

Output can be varied through the cable spacing ranging from 120-150w per square metre in a new build or extension and up to 200w per square metre in a conservatory. This system can be used directly below thick flagstone type flooring.

In-screed underfloor heating loose cable systems are cost effective and are ideal where constant heat is required. For irregular heating such as in a conservatory or areas of infrequent use we suggest using the Varme under tile system with insulation boards or an under wood/laminate carbon mat film system.

Price includes cable and floor sensor. Thermostat options are available.

Key features:

• Ideal for permanent heating of screed floors
• High quality cable design
• Low cost solution
• Can be used for de-icing driveways

The post Varme Electric Underfloor Heating In-Screed Cable Kit appeared first on The Underfloor Heating Site.

Our carbon underfloor heating film is ideally suited for installation directly beneath wood or laminate floors. At less than half a millimetre thick, it has a negligible effect on floor height. The film is laid over our exceptional 6mm Depron floor insulation (which replaces the standard flooring underlay) to give a minimal effect on your floor height – less than 6.5mm in total. This makes it ideal for use in new buildings & renovations or refurbishments where floor height can be vitally important.

As with all of our systems, the film is designed as a heating system (not just floor warming) & gives an even heat coverage beneath the whole floor.

Our carbon heating film is manufactured in the UK in a BEAB approved factory, it is certificated to standard IEC60335 – certificate number NO40430. Floor Heating Systems have sold over 100,000 sqm of the product in the last few years – the quality & reliability is second to non. It comes with a TEN-YEAR manufacturers warranty as standard, but it should last you a lifetime!

Carbon heating film is now available in 3 widths, 102cm, 53cm & 30cm – our design team use the best combination of film to fit your room & for the least number of connections for your electrician
Please email your drawings to sales@theunderfloorheatingsite.co.uk before placing your order.

Each 130w carbon film kit contains:

– 130w carbon heating film roll
– 6mm Depron foam underlay
– Digital programmable thermostat
– 3 metre floor probe
– PE protective film barrier

Please note: Thermal blocks placed over this system may cause damage to:

– The floor covering.
– The underfloor heating system.
– The thermal block.

Thermal blocks are things such as: bean bags, rugs, mattresses, rubber-backed mats, dog beds, etc.

The post Electric Underfloor Heating For Laminate & Wood – Carbon Heating Film Kit 130wm² appeared first on The Underfloor Heating Site.

Varme range of self-regulation frost protection cables are designed to keep water and drainage pipes working and free from ice whatever the weather.
The cables come complete ready to work, fitted with a Molded Plug that plugs straight into any standard house plug socket.
The cable is also fitted with a temperature sensor, so as soon as the temperature drops below 5C the cable is activated and because the cable is self-regulated, it uses the minimum amount of power to maintain the temperature to prevent freezing.

Simple DIY installation Wrap the cable round the pipe, “under any insulation” the cable can be held in place with cable ties or tape. Plug into the mains and it’s protecting your pipe already.

Guaranteed Frost Protection.
Just one burst pipe could cost hundreds of pounds to fix and thousands in damage. Is it worth the risk?
Many uses include:

• Lofts
• Garages
• sheds/summer house
• Outside taps
• Farm buildings

Anywhere with pipes is at risk.

The post Frost Protection Cable 2m – 20m appeared first on The Underfloor Heating Site.